Toyota Ring and Pinion 7.5 Inch 4.56 Ratio Revolution Gear

Toyota Ring and Pinion 7.5 Inch 4.56 Ratio Revolution Gear

This Toyota Ring and Pinion 7.5 Inch set is a Revolution Gear replacement built for Toyota 7.5″ differentials running standard rotation gearing, typically fitted to the rear. Revolution Gear designs it to handle rugged off-road trails and everyday highway driving without compromise.

Specifications

• Gear Rotation: Standard
• Pinion Splines: 23
• Ring Gear Diameter: 7.5 inches
• Ring Gear Bolt Thread: 10 x 10mm
• Carrier Break: No Carrier Break
• Material: 8620 steel
• Country of Manufacture: Korea

This combination keeps noise and wear low over the life of the gear set. This is the same material and heat-treating approach Revolution Gear uses across its wider ring and pinion range.

Toyota 7.5 Inch Crown Wheel and Pinion Fitment

This set suits Toyota 7.5″ differentials running standard rotation gearing, most commonly the rear diff. The 4.56 ratio suits vehicles running close to stock tyre sizes or a modest lift, without giving up much on-road efficiency, and it corrects the power band less aggressively than the taller 4.88 or 5.29 options in this range. Front and rear ratios need to match on most 4WD setups, so check what ratio your front diff already runs before committing to this one.

Why Choose Revolution Gear

Revolution Gear and Axle has built its reputation over more than a decade of street, off-road, and race use. In particular, enthusiasts trust the brand because it delivers consistent quality across a wide range of 4WD and passenger applications. As a result, that track record gives you confidence this gear set will perform as well in your build as it has in thousands of others already on the trail. Not sure if this ring and pinion matches your differential? Get in touch and we’ll help you confirm fitment before you order. For more on Revolution Gear’s Toyota ring and pinion range, see their official product category page.